본문 바로가기
서버/리눅스 서버

#4 [임시글]BPI-R1 스위치 허브 모드로 사용하기 (하나의 VLAN 으로 통합)

by ㅋㅋ잠자 2016. 4. 3.
반응형
  • root@appliance:~# cat /etc/network/if-pre-up.d/swconfig
  • #!/bin/sh
  •  
  • #---------------------------#
  • # BPI-R1 VLAN configuration #
  • #---------------------------#
  • #
  • # This will create the following ethernet ports:
  • # - eth0.101 = WAN (single port)
  • # - eth0.102 = LAN (4 port switch)
  • #
  • # You have to adjust your /etc/network/interfaces
  • #
  • # Comment out the next line to enable the VLAN configuration:
  • #exit 0
  •  
  • ifconfig eth0 up
  •  
  • # The swconfig port number are:
  • # |2|1|0|4|  |3|
  • # (looking at front of ports)
  •  
  • swconfig dev eth0 set reset 1
  • swconfig dev eth0 set enable_vlan 1
  • swconfig dev eth0 vlan 101 set ports '3 8t'
  • swconfig dev eth0 vlan 102 set ports '0 1 2 4 8t'
  • swconfig dev eth0 port 0 set pvid 102
  • swconfig dev eth0 port 1 set pvid 102
  • swconfig dev eth0 port 2 set pvid 102
  • swconfig dev eth0 port 3 set pvid 101
  • swconfig dev eth0 port 4 set pvid 102
  • swconfig dev eth0 set apply 1
  • root@appliance:~# cat /etc/network/interfaces
  • # interfaces(5) file used by ifup(8) and ifdown(8)
  • auto lo
  • iface lo inet loopback
  •  
  • auto eth0.101 eth0.102 br0
  •  
  • iface br0 inet static
  •         bridge_ports eth0.101 eth0.102
  •         address 192.168.200.234
  •         netmask 255.255.255.0
  •         gateway 192.168.200.1
  •  
  • root@appliance:~#
  •    

       

반응형

댓글